Rinex version converter

Related Articles. Trimble Data Transfer Utility v1. How to download a Trimble receiver using the Trimble rfile program Viewed times since Thu, Jul 30, Trimble Remote Controller v2. Subscribe to Knowledge Base Get notified when new articles are added to the knowledge base.

All Categories. Development and Testing Facility-managed Projects General Information 9. Geodetic Imaging Cables and Connectors 6. Comms and Networking Equipment Enclosures 9. GNSS Antennas GNSS Receivers Allen Osborne 6. Javad 2. Leica 3. Magellan Ashtech Septentrio Topcon Trimble Trimble NetR5 Trimble NetR8 Trimble NetR9 Trimble NetRS Trimble Utilities Meteorological Systems Monumentation Power Software and Scripts 3. Tiltmeters 3. If enabled, data is scanned after conversion to correct potential issues.

See Pre-processing Checks for more information. Auto will set the entire file static or kinematic according to the detected processing environment.

The default value is 0 cycles, as most manufacturers remove the offset at the firmware level, but this is not always the case.

The decoder attempts to determine the data interval by reading the header or scanning the observation file. If this fails, enable this option to force an interval. Setting the interval here may be required for successful conversion of RINEX data that contains data gaps in the first minute of the file. This is because data gaps early in the file may cause errors computing the expected data interval. Calculates Doppler from the change in L1 phase measurements between consecutive epochs.

This will produce average velocity values between measurement samples that are relatively noisy. Recomputes Doppler using predicted satellite motion from the broadcast ephemeris. This requires the data to be static and is the best method for recomputing Doppler data for static data.

If a navigation file is either missing or has a different name than the observation file, you will be prompted to select a navigation file. You may define a path to the navigation file manually. This will override the previous option.